Chief Rebar
Dino Challenge No. 3: Chief Rebar's bookshelf

Dino Challenge No. 3 · 5 November 2026

Chief Rebar's bookshelf

Set by Chief Rebar, answered with one calculator

Chief Rebar is putting up a shelf in the site office for the reference books: a pine board 0.75 inch thick and 10 inches deep, resting on two brackets 4 feet apart. Filled end to end with hardbacks it carries about 20 pounds per foot, and pine of this grade has a Young's modulus of about 1,200 ksi.

How far will the middle of the shelf sag? Treat the board as simply supported on the two brackets, and the books as an even load along it.

Hint. The Beam Deflection calculator in the Structural folder. It asks for the board's moment of inertia, which you work out from its depth and thickness. Open the Beam Deflection calculator

The answer

0.27 in

The step the calculator leaves to you is the moment of inertia. For a rectangle lying flat it is depth × thickness³ ÷ 12: 10 × 0.75³ ÷ 12 = 0.352 in⁴. The thickness is cubed, which is why a thin board is far floppier than its weight suggests.

With the 4-foot span, 20 lb/ft and E = 1,200 ksi, the calculator gives 0.27 in of sag at the middle, about 7 mm, or the span divided by 176. That is a sag you can see: US building codes commonly hold a floor to L/360 under people and furniture, which over this span would be 0.13 in. Wood also creeps, so a shelf left loaded for years keeps sinking a little further.

Two cures, both straight from the formula. Glue a second board under the first and the thickness doubles, the moment of inertia goes up eight times and the sag drops to 0.034 in. Or add a third bracket in the middle: each half then spans 2 feet, and because sag grows with the fourth power of the span, each half sags at most a sixteenth as much, about 0.017 in. Chief Rebar went with the bracket, which costs less than a second board.

All the challenges

Educational tool — not a substitute for a licensed engineer or the official code text.