Niki Saura
Lab Note No. 2: The square of speed

Lab Note No. 2

The square of speed

Why doubling a car's speed quadruples its downforce, its drag and its braking distance, and why the power it needs grows faster still.

Presented by Niki Saura · 10 November 2026 · Written by the PhDino author, every number run through the calculators

Every racing car is fighting the same number. Double its speed and the wings press it into the track four times as hard, the air holds it back four times as hard, and on the same grip it needs four times as much road to stop. One quantity sits under all three: the square of the speed. This note follows it through four of PhDino's calculators, and then to the one place where speed bites harder still.

The air sends the bill

Air in front of a moving car has to be pushed aside, and the force it pushes back with depends on its dynamic pressure: half its density times the square of the speed. At sea level and 60 mph that is 441 pascals, about the pressure of a hand resting lightly on a table. Every aerodynamic force is that pressure multiplied by an area and by a coefficient that describes the shape.

Take an illustrative track car with 20 square feet of frontal area, a downforce coefficient of 1.5 and a drag coefficient of 0.75, figures in the range of a car with serious wings. At 60 mph its wings press down with 276 lb. At 120 mph, twice as fast, the downforce is 1,104 lb, four times as much, and at 150 mph it reaches 1,726 lb.

The car weighs 1,653 lb. Somewhere around 147 mph its wings push down harder than gravity does, which is where the old claim comes from that such a car could, in principle, drive upside down on the ceiling of a tunnel. Move the slider to watch each quantity grow with speed.

Figure 1 · Everything grows with speed
×0×4×8×12×16×20×24×280306090120150180white: downforce, drag, braking distance (v²)coral: power against drag (v³)speed, mphtimes the value at 60 mph
120 mph: downforce 1,104 lb (67% of the car's weight) · drag 552 lb · 177 hp against drag · stop on grip alone 321 ft, with downforce 246 ft

Drag, and the cube

Drag follows the same square. At 60 mph the air holds the car back with 138 lb. The engine does not merely have to match that force; it has to go on matching it while the car covers ground, and power is force multiplied by speed. So the power spent against drag grows with the cube of the speed: 22 hp at 60 mph, 177 hp at 120 mph and 345 hp at 150 mph.

Twice the speed takes eight times the power. That is why top speeds creep up so slowly as engines grow: with twice the power of an otherwise identical car, a car is only about 26% faster where drag is all that holds it back.

Stopping from speed

Braking carries the square for a different reason. A moving car stores kinetic energy, half its mass times its speed squared, and the brakes must turn all of it into heat. With constant grip, the distance follows the energy: from 150 mph on slick tyres that hold 1.5 g, the Braking Distance calculator gives 501 ft.

This car does not have constant grip. Tyres can push back harder the harder they are pressed into the road, and at 150 mph the wings add more than the car's own weight. At that speed it can slow at about 3.1 g, easing back towards 1.5 g as the downforce fades with the speed. Work the stop out with that changing grip and it takes 343 ft, about 31% shorter. The square that piles up drag on the straight pays some of it back in the braking zone, which is why racing cars can brake so late for fast corners.

What a few miles an hour are worth

On a 2.5-mile oval lapped at an average of 100 mph, a lap takes 90.0 s. Find two miles an hour more and the Lap Time Delta calculator gives 88.24 s, 1.76 s quicker on every lap, or 71 seconds over a 40-lap race.

Where would the speed come from? If it had to come from the engine alone, on a track where drag sets the pace, a 2% gain in speed needs about 6.1% more power, three times as much in proportion. Downforce is the other route, buying grip for faster corners, but every pound of it brings drag along with it. The table puts each gain in lap time beside the power it would cost.

Figure 2 · A faster lap, and what it costs
Average speed gain on a 2.5-mile oval at 100 mphNew average, mphLap time saved, sExtra power if drag sets the pace
1%1010.893.0%
2%1021.766.1%
5%1054.2915.8%
10%1108.1833.1%

What this model leaves out

Real coefficients change with ride height, steering angle and how close the car runs behind another. Air thins with altitude and heat, which lowers every force here. Tyres also lose a little of their grip coefficient as the load on them rises, so downforce shortens a stop by somewhat less than the simple sum above. Rolling resistance, which grows only slowly with speed, matters at low speed and is left out. The car is illustrative: chosen to show the shape of the laws, not to describe any real machine.

Every number on this page comes from running PhDino's calculators, and the key values are checked against independent working each time the site is built. The calculators are below if you want to try your own car.

Try the numbers yourself

  • Aerodynamic Downforce: Downforce generated at a given speed, frontal area, and downforce coefficient
  • Drag Equation: Aerodynamic drag force from airspeed, reference area, and drag coefficient
  • Braking Distance: Braking distance and total stopping distance including reaction time
  • Lap Time Delta: Estimated lap time change from a change in average lap speed
Educational tool — not a substitute for a licensed engineer or the official code text.